November, 2026
now browsing by month
Why Adding More Powder Coating Makes Pinholes Worse (And What Actually Works)
A few years ago, a job shop running die-cast aluminum parts had a rejection rate hovering around 30% because of pinholes. The first instinct on the floor was predictable: spray a heavier coat. If the pinholes are breaking through the surface, put down more powder and bury them. That instinct is almost always wrong. On thick-film powder coatings, adding material does not hide the defect—it multiplies it. The reason sits at the intersection of substrate chemistry and film physics, andRead More …
How to Prevent Back Ionization in Powder Coating: Causes, Warning Signs, and Practical Solutions
In electrostatic powder coating, achieving a smooth and uniform finish depends on more than just powder quality. Even when the powder formulation is correct and the application equipment is functioning normally, certain electrostatic conditions can still lead to unexpected surface defects. One of these problems is back ionization. Back ionization is particularly frustrating because it can occur during an otherwise normal spraying process. Operators may notice small craters, pinhole-like marks, uneven film appearance, or rough surface areas after curing. InRead More …
Troubleshooting Poor Adhesion in Powder Coatings: What Actually Works on the Shop Floor
Poor adhesion remains one of the most frustrating failures in powder coating. The film looks fine when it leaves the oven, then chips, peels, or lifts weeks or months later under normal use. Most of the time the powder itself is not the main culprit. Surface preparation and process control usually are. Why adhesion fails more often than people expect Powder coatings rely on mechanical interlocking and chemical bonding with the substrate. If the surface is contaminated, oxidized, orRead More …

D5 Creation